Is There A Fuel Filter On A 2005 Chrysler Sebring

How to Replace a Fuel Filter for a Chrysler Sebring V6 3.0L

by Jeremy Holt

Creatas/Creatas/Getty Images

The Chrysler Sebring is i of only a few mid-sized sedans with a soft-top option. First manufactured in 1995, the Sebring offers reliable motoring at a reasonable cost. Parts are like shooting fish in a barrel to come up by, and many maintenance tasks are unproblematic and straightforward. Chrysler recommends replacing the fuel filter every 60,000 miles. The task is a chip challenging, but it is one that you should exist able to practice yourself, saving you time and labor charges at the automobile repair shop.

Step 1

Raise the hood and prop it open. Locate the power distribution heart on the driver's side over the front wheel. Pull the fuel pump relay fuse (#28) out with your fingers. Plough the ignition and attempt to start the machine; if information technology runs, allow it to stall. Plough off the ignition. Salve force per unit area in the fuel tank by removing the gas cap. Remove the negative cablevision from the battery with an adjustable wrench.

Step 2

Open the trunk. Lift the left side of the flooring mat. Locate the 4-pin electrical connector of the fuel pump module and disconnect it from the harness. Locate the safety trunk grommet nigh the base of the rear seat. Push button the grommet out and pass the wiring through the hole in the trunk.

Step 3

Heighten the rear of the car with a flooring jack and lower the Sebring onto jack stands. Place a large fuel container under the fuel tank drain. Remove the plug and drain the fuel into the container. Replace the bleed plug. Shop the fuel away from sources of burn down or sparks.

Step four

Position a transmission jack under the fuel tank and heighten the jack so it supports the fuel tank. Disconnect the fuel tank strap on the driver's side by removing the bolts; loosen the strap on the passenger'southward side. Lower the transmission jack and the fuel tank.

Stride 5

Locate the fuel filter mounted to the rear frame above the fuel tank. Release the fuel filter hose connectors from the fuel filter; clasp the tabs and pull the hoses off. Fuel may still be in the lines and filter, then collect any leftover fuel in a container and mop up any spills with a rag. Remove the fuel filter.

Step 6

Connect the new filter to the fuel lines and mountain the filter to the frame. Replace the safe body grommet and fuel pump module electrical connector into the body. Raise the fuel tank back into identify with the transmission jack. Attach the straps to the tank and tighten the bolts.

Reconnect the four-pin fuel pump module electrical connector to the harness in the torso. Replace the mat in the trunk. Fill the fuel tank. Supervene upon the fuel pump relay fuse under the hood. Reconnect the negative clamp to the battery concluding. Showtime the Sebring to examination the system.

References

Tips

• Get-go this job when your fuel tank is low. You need to drain the fuel tank to replace the fuel filter.

Things You'll Need

• Jack
• Jack stands
• Adaptable wrench
• Socket set
• Fuel container
• Rags

Warnings

• Gasoline is extremely flammable; clean upwardly spills immediately.
• Continue naked flames and sparks away from the fuel arrangement.
• Do non allow dirt or debris into the new filter or fuel lines.

Author Bio

Based in Middletown, Delaware, Jeremy Holt has worked as a author, copy-editor and proofreader for MBNA Corporation, Rahli Inc. and Kreativz.com. since 1998. Built-in and educated in the United Kingdom, he holds a Bachelor of Science degree in psychology from the University of Glamorgan.

More Articles

Is There A Fuel Filter On A 2005 Chrysler Sebring,

Source: https://itstillruns.com/replace-chrysler-sebring-v6-30l-7396729.html

Posted by: yudeppoccanot85.blogspot.com

Share this post